2019 the TroPro trade exh…
How to adjust the laser beam path
How to install new laser tube
How to disassemble your Nova
Release Time：2019/07/08 General Question Browsing Times：480
The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova
Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anything when moving.
Please do as following:
1. Remove the front door, the honeycomb table and the blades. (To reduce the weight and make it easier to move)
2.Remove the Tower Alarm Lamp;
PS ： disconnect the wire from the connector （ 24V4 to green ； 24V5 to red ； 0V3 to black ）
3. Fix the top lid.
4. Unscrew all the screws at the foot stand. There are 8 screws on each side.
5. Move the machine upper part with a trolley
6. After moving all the parts to your room, please reassemble them by fix 8 screws on each side.
End
Please do as following:
1. Remove the front door, the honeycomb table and the blades. (To reduce the weight and make it easier to move)
2.Remove the Tower Alarm Lamp;
PS ： disconnect the wire from the connector （ 24V4 to green ； 24V5 to red ； 0V3 to black ）
3. Fix the top lid.
4. Unscrew all the screws at the foot stand. There are 8 screws on each side.
5. Move the machine upper part with a trolley
6. After moving all the parts to your room, please reassemble them by fix 8 screws on each side.
End
Related Pages
