2019 the TroPro trade exh…
How to adjust the laser beam path
How to install new laser tube
-
How to calibrate the working table to level.
Release Time：2016/12/07Browsing Times：1041
There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of ...
-
Some point of the same piece of materials can not be cut through, why
Release Time：2016/12/06Browsing Times：1016
Some point of the same piece of materials cannot be cut through, why? This problem is mainly caused by following three reasons: 1. The cutting material is bent (not flat) or uneven density. 2. T...
-
Why the laser has no laser beam?
Release Time：2016/11/29Browsing Times：1168
Following reasons cause the failure of laser working (has no laser beam) 1. Cooling system problem (includes water chiller) 2. Laser power supply (optical coupled isolator) or Laser tube 3. Wiri...
-
Why the Y axis cannot work suddenly?
Release Time：2016/11/28Browsing Times：1304
1. Please check if the rotary switch is turned on,like below: PS: Turning to "O" off means all is normal. If it is "-", please turn off to “O” and press the reset on control panel. 2. if t...
-
Why does the cutting and engraving graphics reverse (mirror)
Release Time：2016/11/23Browsing Times：1312
This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. ...
-
Why does the graphic size that imported to RDWorks different from its original size
Release Time：2016/11/21Browsing Times：1250
If the file being imported is DXF format, the problem may be caused by improper software setting. For example, the unit of the original DXF file is “inch”, but in RDWorks, the DXF unit is set as “...
-
How to run several laser machines with one PC
Release Time：2016/11/17Browsing Times：822
If there are several USB interfaces with your PC, it's able for one PC (laser software) to connect with several machines. But pc will does only communicate with one machine and sending the f...
-
How to install the CorelDraw plugin for RDWorks
Release Time：2016/11/11Browsing Times：1967
1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_L...
