2019 the TroPro trade exh…
How to adjust the laser beam path
How to install new laser tube
-
Air pump won’t work or no air assist when job starts
Release Time：2019/06/01Browsing Times：509
Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, th...
-
Exhaust fan cannot extract smoke or dust
Release Time：2019/06/01Browsing Times：853
Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then che...
-
How to prepare your files for feeding into the laser program to cut
Release Time：2019/06/01Browsing Times：482
Scenario 1: If the vector has overlapped paths and it will be cut repeatedly. Solution： In RDworks, you can use “Delete overlap” tool to delete all overlapped paths, like...
-
How to prepare your files for feeding into the laser program to engrave
Release Time：2019/06/01Browsing Times：793
Note: the laser machine can only burn into or through material. Also, the beam can only be made to follow straight or curved paths or to burn a grid of dots (a bitmap image). There is no way for ...
-
Cutting problem– Some point of the same piece of materials cannot be cut through
Release Time：2019/06/01Browsing Times：510
Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. ...
-
Engraving problem—how to Improve Engraving Quality in the scan mode of X-swing
Release Time：2019/06/01Browsing Times：744
The engraving quality working on x-swing is generally worse than x-unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below. In ...
-
Engraving problem—the engraving quality is very poor
Release Time：2019/06/01Browsing Times：457
Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic....
-
The laser tube won’t fire the beam
Release Time：2019/06/01Browsing Times：518
Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing ...
