2019 the TroPro trade exh…
How to adjust the laser beam path
How to install new laser tube
-
Maintenance manual for Thunder laser system
Release Time：2019/07/08Browsing Times：586
Proper care and routine maintenance of the machine will ensure optimal performance over a long service life. DAILY CHECK LIST ☑ Focus lens WEEKLY CHECK LIST ☑ Reflector &...
-
How to disassemble your Nova
Release Time：2019/07/08Browsing Times：479
The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anyt...
-
Operation manual for Thunder laser machine
Release Time：2019/07/08Browsing Times：560
Operation manual for Thunder laser machine To be safe, never ever run the laser system unattended. According to international standard，“O”means close；“I”means open for the rocker switc...
-
User manual for LCD control panel
Release Time：2019/07/08Browsing Times：446
Contents 1 Function of the Buttons……………………………………2 2 The main interface……………………………………4 2.1 Speed Key……………………………………5 2.2 Max Power Keys……………………………………5 2.3 Set the Layer Parameters…………………...
-
Why the red dot pointer not being able to come out from the laser head.
Release Time：2019/06/01Browsing Times：559
Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, ple...
-
Why the “Origin” button of LCD panel not working
Release Time：2019/06/01Browsing Times：547
Here are the reasons: ● The starting point is set to absolute coordinate in software. Locate on the bottom left corner, the option of “Position” please select to Current positio...
-
How do i replace the controller board
Release Time：2019/06/01Browsing Times：657
Firstly, turn off the whole machine power. Remove Old Part: Open the lower right hand door panel, find the main controller board, like below. Unplug all connectors on the controller bo...
-
Chiller alarms unusually
Release Time：2019/06/01Browsing Times：545
Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Kee...
